Kramer’s Best

Donna met a new friend, Johanna, playing pickleball at the Pacific Beach Recreation Center (PBRC). They’re planning to ride their bicycles up to Torrey Pines on Friday. So fixing her bicycle became a priority – the shifter cable for the rear derailleur broke on her last ride.

Donna had an appointment for her annual check up Wednesday morning so I scootered her up to Washington Street. After her appointment, we went to Lanna Thai on Mission Bay Drive (map) for lunch. Pad Thai is a favorite for both Donna and me – they make a good Pad Thai there.

After lunch, I got to work on Donna’s bike. I set up my Cycle Pro bike stand outside the cargo trailer and mounted Donna’s bike on it. Her bike is equipped with Shimano Ultegra brakes and derailleurs. The brake lever applies the brakes when you pull the lever toward the handlebar. If you push the lever toward the center of the bike, it works as a shifter. It does this by applying tension or releasing tension on cable through a ratcheting drum mechanism inside the brake lever hood.

New shift cable

New shift cable

I removed the old cable and threaded the new cable in place. I cut the cable to size, allowing a few spare inches. Then I tried the shifter. Oops! It didn’t work. I looked at the drum again and realized the cable wasn’t connected to the drum properly. In fact, the drum was stuck and wouldn’t return to the spring-loaded rest position so I could thread the cable through the drum properly.

I had to remove the new cable and start over. After poking and prodding around, I finally saw a few strands of wire. Part of the old cable was stuck in the drum, wedging it in place. This was why the drum wouldn’t return to the spring-loaded rest position. I spent the next 20 minutes trying to get the piece of stuck cable out. I was eventually able to grip the barely visible wire strands with a small hemostat and work it free. Once the old cable end was out, the drum rotated from the internal spring pressure to the stop. Now I could thread the cable through the drum and route it back to the derailleur.

I was glad I left a few extra inches of cable when I cut it so I had something to work with as I tensioned the cable and adjusted the shifter. Donna’s bike is back in business. The 15 to 20 minute job took me over an hour!

With that job done, we scootered over to the new Trader Joe’s location on Garnet Avenue in Pacific Beach, one block west of Vons. The new store is brighter and airier than the old location was.

After shopping at Trader Joe’s, I was ready for a cold one and went to the Offshore Tavern and Grill. I was hoping to run into Butch there. Butch won the football pool last week. Traditionally, the winner of the pool buys a round for the other pool entrants – usually on Tuesday night. Butch didn’t show up Tuesday and he wasn’t there Wednesday either. I hope he’s okay.

Around 6pm, UPS delivered a package. It was something I needed for another project. Somewhere on the web I read about a wood refinishing product – I don’t remember where I heard about it or the exact story I read. The gist of it was this – a couple had a motorhome and the cabinets were in need of refinishing. They had a friend who was a cabinet maker. They invited him over to look at their cabinets. The proposed a trade. They would give him stereo equipment worth several hundred dollars if he would repair the finish on their cabinets. He agreed to the barter.

Later, he came over and went to work. He spent all of half an hour wiping the cabinets with a special product, then rubbing them dry with a cloth. The people were amazed – the cabinets looked like new. The magic product is called Kramer’s Best Antique Improver.

Kramer's Best Antique Improver

Kramer’s Best Antique Improver

We have a cabinet that had something spilled on it and I thought the finish was ruined. I don’t remember how it happened, but I wanted to repair it. The Kramer’s product isn’t cheap, but I thought it was worth a try so I ordered it online. This morning, I wiped the damaged wood on the cabinet door with Kramer’s on a square of cotton cloth from an old T-shirt Donna’s been after me to quit wearing. After I applied the Kramer’s, I used a fresh, clean cotton cloth and rubbed it dry. I didn’t spend more than five minutes on it. Here are the results:

Damaged finish on wood cabinet door

Damaged finish on wood cabinet door

Rub on, rub off with Kramer's and it's job done

Rub on, rub off with Kramer’s and it’s job done

I don’t have any affiliation with Kramer’s in any way. But this stuff is amazing and I wanted to share the results. I’ll tackle our dining table and chairs next and touch up a few other cabinets.

The weather continues to be agreeable. We should see mid to upper 70s today and through the weekend. Overnight lows have been in the 50s – perfect sleeping weather. I need to scooter over to Costco this morning, then Donna and I will go to the PBRC for more pickleball action this afternoon.

 

*Just so you know, if you follow one of my links to Amazon and decide to make a purchase, you pay the same price as usual and  I’ll earn a few pennies for the referral. It’ll go into the beer fund. Thanks!

 

4 thoughts on “Kramer’s Best

  1. Maryann

    Couple things. Congrats on your daughter getting her law degree. Next, when you put this “oil” on the cabinets does it leave it a little greasy? Can it be used on any type of wood? Thanks for your very detailed website.

    1. Mike Kuper Post author

      Thanks Maryann. The key to using Kramer’s is to rub it dry with a clean, soft cloth. The cabinet door isn’t greasy or oily at all. It doesn’t take much effort – it’s an amazing product.

  2. Nancy Boatright

    Mike-My sister has a beautiful dining room table that my daughter accidentally spilled finger nail polish remover on and messed up the finish. Do you think that the Kramer product could repair that damage? I hope so!

Comments are closed.